Removal (Fig. 49)
Park machine on a level surface, lower cutting
decks, stop engine, apply parking brake and remove
key from the ignition switch.
3. Usingtagsplacedduringreservoir removal,properly
connect hydraulic hoses to reservoir fittings and secure
with hose clamps.
1.
4. If hose guard (item 33) was removed, install guard
with split orientated up and secure with two (2) cable
ties.
2.
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Read the General Precautions for Removing and
5. Slide fuel tank to proper location on machine and se-
cure in place (see Fuel Tank Installation in the Service
and Repairs section of Chapter 3 -- Diesel Engine).
3.
hydraulic reservoir removal,thoroughlycleanexteriorof
reservoir, fittings and hoses.
To prevent contamination of hydraulic system during
6. Fill reservoir with new hydraulic fluid.
4.
Remove drain plug and empty reservoir into a suit-
able container.
3
2
2
5.
To allow access to reservoir fasteners, loosen fuel
tank and slide it toward left side of machine (see Fuel
Tank Removal in the Service and Repairs section of
Chapter 3 -- Diesel Engine).
1
4
6.
fy their correct position on the reservoir.
To ease assembly, label all hydraulic hoses to identi-
NOTE: Original production clamps used to secure
hoses to stand pipes and hydraulic tubes are crimped
and will need to be cut in order to remove hoses (Fig.
50).
Replacement clamps are traditional worm clamps.
7.
Put caps or plugs on fittings and hoses to prevent con-
tamination.
Disconnect hydraulic hoses from reservoir fittings.
Figure 50
3.
4.
8.
guide.
Remove hydraulic reservoir using Figure 49 as a
1.
2.
Stand pipe
Hose clamp
Hose
Hydraulic tube
Inspection
1.
Clean hydraulic reservoir and tank strainer with sol-
vent.
2.
Inspect reservoir for leaks, cracks or other damage.
Installation (Fig. 49)
1.
Install reservoir using Figure 49 as a guide.
A. Torque drain plug (item 22) from 155 to 171 in--lb
(18
to 19 N--m).
B. Torque tank strainer (item 23) from 105 to 115 ft--
lb (143 to 155 N--m).
2.
Remove caps or plugs placed during removal to pre-
vent contamination.
Groundsmaster 5900/5910
Page 4 -- 67
Hydraulic System
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 5900, Toro Groundsmaster 5910 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)