Remove Brake Assembly (Fig. 2)
Park machine on a level surface, lower cutting
decks, stop engine and remove key from the ignition
switch. Do not apply parking brake.
10.Remove splined brake coupler (item 2).
1.
11.Complete brake inspection and repair (see Brake
Service in this section).
2.
3.
Drain oil from planetary/brake assembly.
Chock rear wheels to prevent machine from shifting.
CAUTION
1
When changing attachments, tires or perform-
ingotherservice,use correct blocks, hoistsand
jacks to raise and support machine. Make sure
machine is parked on a solid level surface such
as a concrete floor. Prior to raising machine, re-
move any attachments that may interfere with
the safe and proper raising of the machine. Al-
ways chock or block wheels. Use appropriate
jack stands to support the raised machine. If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
2
3
Figure 3
1.
2.
Wheel motor
Brake assembly
3.
Drain plug
4.
Chapter 1 -- Safety). Support machine with appropriate
jack stands.
Jack up front of machine (see Jacking Instructions in
4
3
5.
6.
Motor Removal in the Service and Repairs section of
Chapter 4 -- Hydraulic System).
Remove front wheel assembly.
Remove hydraulic wheel motor (see Front Wheel
1
2
Figure 4
7.
bly pull rod:
Disengage brake lever (item 14) from brake assem-
1.
2.
Splined brake coupler
Brake coupler step
3.
4.
Hydraulic motor end
Planetary assembly end
A. Remove tension on brake cable.
3
4
B. Remove cotter pin (item 13) that secures brake
lever to front axle frame.
1
C. Slide clevis pin (item 17) from axle frame bracket
and brake lever. Remove two (2) washers (item 16)
from between brake lever and frame bracket (Fig.5).
D. Shiftbrakelevertowardthecenterofthemachine
todisengageleverslotfrompullrodonbrakeassem-
bly.
2
4
8.
Remove four (4) flange head screws (item 9) that se-
Figure 5
cure brake assembly to machine. Remove brake as-
sembly from machine. Take care to not drop splined
brake coupler (item 2) as brake assembly is removed.
1.
2.
Brake lever
Cotter pin
3.
4.
Frame bracket
Washer
9.
Remove and discard gasket (item 7). Make sure that
allgasketmaterialisremovedfrombothbrakeandplan-
etary assemblies.
Groundsmaster 5900/5910
Page 6 -- 7
Axles, Planetaries and Brakes
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 5900, Toro Groundsmaster 5910 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)