Removal (Figs. 11 and 13)
Park machine on a level surface, lower cutting
2
1.
decks, stop engine, apply parking brake and remove
key from the ignition switch.
1
2.
blade spindle.
Remove covers from cutting deck to allow access to
1
3.
motor from cutting deck (see Cutting Deck Motor Re-
moval in the Service and Repairs Section of Chapter 4
If drive spindle is to be serviced, remove hydraulic
--
Hydraulic Systems). Position motor away from
spindle.
4.
to release belt tension. Remove drive belt from spindle
to be serviced.
Using appropriate socket wrench, loosen idler pulley
Figure 12
1.
Flange head screw
2.
Hydraulic motor
5.
gine and remove key from the ignition switch. Latch or
block up the cutting deck so it cannot fall accidentally.
Start the engine and raise the cutting deck. Stop en-
2
1
3
6.
Remove cutting blade, anti--scalp cup and blade bolt
from spindle to be serviced.
7.
Remove spindle housing assembly from deck.
A. For driven spindle assemblies, remove eight (8)
flange head screws with flange nuts that secure
spindle to deck.
B. Fordrivespindle assemblies, loosen andremove
four (4) flange head screws with flange nuts that se-
cure spindle to deck. Then, remove four (4) cap
screws with washers that secure spindle and hy-
draulic motor mount to deck.
8
5
9
4
88
to 108 ft--lb
to 146 N--m)
C. Lift spindle assembly from deck.
(119
6
7
Installation (Figs. 11 and 13)
Position spindle on cutting deck noting orientation of
grease fitting(Fig.11).Securespindleassembly todeck
with correct fasteners.
1.
Figure 13
1.
Drive spindle
Driven spindle
Flange head screw
Flange nut
6.
7.
8.
9.
Anti--scalp cup
Blade bolt
Flat washer
Cap screw
2.
3.
4.
5.
2.
Install cutting blade, anti--scalp cup and blade bolt to
spindle. Tighten blade bolt from 88 to 108 ft--lb (119 to
N--m).
Cutting blade
146
3.
Slowly rotate cutting blades to verify that blades do
not contact any deck components.
4.
5.
to cutting deck (see Cutting Deck Motor Installation in
the Service and Repairs Section of Chapter 4 -- Hydrau-
lic Systems).
Install drive belt tospindle pulleys and idler pulley(s).
If drive spindle was removed, install hydraulic motor
6.
Install covers to cutting deck.
Groundsmaster 5900/5910
Page 8 -- 15
Cutting Decks
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 5900, Toro Groundsmaster 5910 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)