Toro 10176SL Service Manual Models 30448 30446 Groundsmaster 4000 4010 D D Preface

Procedure for Engine Cooling Fan Circuit Test
Make sure hydraulic oil is at normal operating tem-
1.
perature  by  operating  the  machine  under  load  for
approximately ten (10) minutes. Make sure the hydrau-
lic tank is full.
2
2.
decks lowered and off. Make sure engine is off and the
parking brake is applied. Raise and support hood.
Park machine  on  a level  surface with  the cutting
1
CAUTION
Prevent personal injury and/or damage to equip-
ment. Read all WARNINGS, CAUTIONS and Pre-
cautions for Hydraulic Testing at the  beginning
of this section.
Figure 52
1.
Fan drive manifold
2.
Test port G1
3.
Raise seat to gain access to the fan drive manifold
(Fig.52).Connecta5,000PSI(345bar)pressuregauge
with hydraulic hose attached to test port on top of man-
ifold.
2
4.
(2870
Start the  engine. Move throttle  to high  idle speed
RPM).
5.
While monitoring  the pressure gauge  and using a
1
phototac to identify the  cooling fan speed, disconnect
the  wire  harness  connector (white/green  and  black
wires) from the PRV solenoid on fan drive manifold (Fig.
53).
Both fan speed and pressure should increase and
stabilize after the solenoid is disconnected.
PRESSURE  GAUGE READING  TO  BE  approxi-
mately 3000 PSI (207 bar).
Figure 53
2.
PHOTOTAC READING TO BE: fan speed should be
at least 2800 RPM.
1.
Fan drive manifold
PRV solenoid
6.
7.
bar) but fan speed is low, consider that the fan motor is
worn or damaged. If pressure and fan  speed are both
low, consider that the gear  pump is worn or damaged
(see Engine Cooling Fan Circuit Gear Pump Flow Test
in this section).
Stop engine and record test results.
If pressure  rises to  approximately  3000 PSI (207
NOTE:  Ifpressure and fan speed are bothlow andgear
pump flow proves tobe correct, suspect thatseals infan
drive manifold are leaking or faulty (see Fan Drive Man-
ifold Service in the Service and Repairs section of this
chapter).
8.
andreconnectwireharnesstoPRVsolenoid.Lowerand
secure hood and operator seat.
When testing is complete, remove pressure gauge
Groundsmaster 4000--D/4010--D
Page 4 -- 67
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 340 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website