Toro 10176SL Service Manual Models 30448 30446 Groundsmaster 4000 4010 D D Preface

Removal (Fig. 71)
Park  machine  on  a  level  surface,  lower  cutting
decks, stop  engine, apply parking  brake and remove
key from the ignition switch.
Installation (Fig. 71)
1.
IMPORTANT: Refer to  Traction Circuit Component
Failure in  the General  Information section of  this
chapter for information regarding the importance of
removing contamination from the traction circuit.
2.
Read the  General Precautions  for Removing  and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
1.  If fittings  were removed from  motor, lubricate  and
place new O--rings onto fittings. Install fittings into port
openingsusingmarksmadeduringtheremovalprocess
to properly  orientate fittings. Tighten  fittings (see Hy-
draulic  Fitting Installation  in the  General Information
section of this chapter).
NOTE:  Toeaseinstallation,labelthehydraulichosesto
show their correct position on the axle motor.
3.
Disconnect hydraulic hoses from motor. Put caps or
plugs on motor ports and hose openings to prevent con-
tamination.
2.
Ifremoved,installpiniongear(item10)toaxlemotor.
3.
Install O--ring (item 6) onto motor. Position motor to
IMPORTANT: Support axle motor to prevent motor
from falling during removal.
rear axle assembly making sure that arrows on the side
of motor case point upward. Align gear teeth and slide
motor into place.
4.
Remove motor from rear axle using Figure 71 as a
guide.
4.
Secure motor to axle with cap screws and flat wash-
ers. Torque screws from 59 to 73 ft--lb (80 to 99 N--m).
5.
If hydraulic  fittings are to be  removed from motor,
mark fitting orientation  to allow correct assembly. Re-
move fittings from motor and discard O--rings.
5.
Remove plugs from motor ports and hose openings.
Using labels placed during motor removal, correctly at-
tach hydraulic hoses to axle motor (see Hydraulic Hose
and Tube Installation in the General Information section
of this chapter).
6.
Fill reservoir with hydraulic fluid as required.
7.
Properly fill hydraulic system (see Charge Hydraulic
System in this section).
8.
hoses and fittings do not contact anything.
After assembly  is completed,  verify that  hydraulic
Groundsmaster 4000--D/4010--D
Page 4 -- 91
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 340 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website