Toro 10176SL Service Manual Models 30448 30446 Groundsmaster 4000 4010 D D Preface

Procedure for Traction Circuit Reducing Valve (PR)
Pressure Test
1
1.
Make sure hydraulic oil is at normal operating tem-
perature  by  operating  the  machine  under  load  for
approximately ten (10) minutes. Make sure the hydrau-
lic tank is full.
2.
decks lowered and off. Make sure engine is off and the
parking brake is applied.
Park machine  on  a level  surface with  the cutting
2
CAUTION
Figure 35
1.
4WD manifold
2.
Pressure test port
Prevent personal injury and/or damage to equip-
ment. Read all WARNINGS, CAUTIONS and Pre-
cautions for Hydraulic Testing at the  beginning
of this section.
1
3.
port on 4WD manifold under radiator (Fig. 35).
Connect a 1000 PSI (70 bar) pressure gauge to test
4.
(2870
Start the engine and put throttle  at high idle speed
RPM). Make sure that Hi/Low speed switch is in
the Low speed (4WD) position.
2
5.
traction pedal  in the reverse direction.  While pushing
traction pedal, look at pressure reading on gauge:
Siton seat,apply brakes fully andslowly depress the
Figure 36
1.
4WD manifold (front)
2.
Reducing valve (PR)
GAUGE READING TO  BE approximately 650 PSI
(45
bar).
6.
7.
side of the 4WD manifold (Fig. 36). Adjustment of  this
valve can be performed as follows:
Stop engine and record test results.
Pressure reducing valve (PR) is located on the front
1
NOTE:  Do not  remove  the pressure  reducing  valve
from the hydraulic manifold for adjustment.
A.  To increase pressure setting, remove cap on re-
ducing valve and turn the adjustment socket on the
valve in a clockwise direction. A 1/8 turn on the sock-
et will make a measurable change in pressure set-
ting.
2
B.  To decrease pressure setting, remove cap on re-
ducing valve and turn the adjustment socket on the
valve in a counterclockwise direction. A 1/8 turn on
the socket will make a measurable change in pres-
sure setting.
Figure 37
C. Recheck pressure setting and readjust as need-
ed.
1.
Relief valve cap
2.
Adjustment socket
8.
When  testing  is completed,  disconnect  pressure
gauge from manifold test port.
Groundsmaster 4000--D/4010--D
Page 4 -- 47
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 340 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website