Toro 10176SL Service Manual Models 30448 30446 Groundsmaster 4000 4010 D D Preface

Procedure for Steering Circuit Relief Pressure Test
Make sure hydraulic oil is at normal operating tem-
perature  by  operating  the  machine  under  load  for
approximately ten (10) minutes. Make sure the hydrau-
lic tank is full.
7.  If pressure is incorrect, inspect steering relief valve
in steering control valve (see Steering Control Valve in
the Service and Repairs section of this chapter). If relief
valveisoperatingproperlyandiflift/lower    problemsalso
exist, flow  divider  in fan  manifold and/or  gear pump
(third section) should be suspected of wear and ineffi-
ciency.Ifsteering  wheelcontinues toturnatendofcylin-
der  travel  (with  lower  than  normal  effort),  steering
cylinder or steering control valve should be suspected
of wear or damage.
1.
2.
decks lowered and off. Make sure engine is off and the
parking brake is applied.
Park machine  on  a level  surface with  the cutting
8.
gauge from test port.
When  testing  is completed,  disconnect  pressure
CAUTION
Prevent personal injury and/or damage to equip-
ment. Read all WARNINGS, CAUTIONS and Pre-
cautions for Hydraulic Testing at the  beginning
of this section.
1
3.
necta5000PSI(350bar)pressure    gaugeontotestport.
Locate steering circuit  pressure test port and  con-
A.  On Groundsmaster 4000--D machines,  the test
port is located on the steering supply hydraulic tube
under the front of the machine (Fig. 49).
B.  On Groundsmaster 4010--D machines,  the test
port is located on the steering supply hydraulic tube
under the operator seat (Fig. 50).
Figure 49
1.
Steering circuit pressure test port (GM4000--D)
4.
Start the engine and move throttle tohigh idleengine
speed (2870 RPM).
IMPORTANT: Hold steering  wheel at full lock  only
longenoughtogetasystemreliefpressurereading.
Holding the steering wheel against the stop for an
extended period can  damage the steering  control
valve.
1
5.
mentarily hold the steering wheel against resistance.
Turn steering all  the way in one direction  and mo-
GAUGE READING TO BE 1300 to 1400 PSI (90 to
96
bar).
Figure 50
Steering circuit pressure test port (GM4010--D)
6.
Stop the engine and record test results.
1.
Groundsmaster 4000--D/4010--D
Page 4 -- 61
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 340 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website