Toro 10176SL Service Manual Models 30448 30446 Groundsmaster 4000 4010 D D Preface

Removal (Fig. 106)
Read the  General Precautions  for Removing  and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Installation (Fig. 106)
1.
1.  If fittings were removed from manifold, lubricate and
place new O--rings onto fittings. Install fittings into man-
ifold openings  using marks made  during the removal
process  to properly  orientate fittings.  Tighten fittings
(see Hydraulic Fitting Installation in  the General Infor-
mation section of this chapter).
2.
manifold  removal, thoroughly  clean  exterior  of  PTO
manifold and fittings.
To prevent contamination of hydraulic system during
2.
as a guide.
Install PTO manifold to the frame using Figure 106
3.
noid valve coil on the PTO manifold.
Disconnect wire harness  connector from the  sole-
NOTE:  Make sure that lock washer and ground cable
arepositioned underuppercapscrewheadwheninstal-
ling RH PTO manifold.
4.
caps or plugs on open hydraulic lines and fittings. Label
disconnected hydraulic lines for proper installation.
Disconnect hydraulic  lines  from manifold  and put
3.
Remove caps and plugs from fittings and hoses. Us-
5.
106
Remove PTO manifold from the frame using Figure
as a guide.
inglabelsplacedduringmanifoldremoval,properlycon-
necthydrauliclinestomanifold(seeHydraulicHoseand
Tube Installation in the General Information section  of
this chapter).
NOTE:  The upper  cap screw  on the  right side  PTO
manifold also secures the ground cable and has a lock
washer to ensure  a good grounding  path. Make sure
that lock washer is  retrieved when removing RH PTO
manifold from frame.
4.
valve coil on the PTO manifold.
Connect  wire harness  connector  to  the solenoid
5.
essary before returning machine to service.
Makesurehydraulic  tankisfull.Addcorrectoilifnec-
6.
mark fitting orientation  to allow correct assembly. Re-
move fittings from manifold and discard O--rings.
If hydraulic fittings are to be removed from manifold,
Groundsmaster 4000--D/4010--D
Page 4 -- 135
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 340 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website