Toro 10176SL Service Manual Models 30448 30446 Groundsmaster 4000 4010 D D Preface

Removal (Fig. 87)
Park  machine  on  a  level  surface,  lower  cutting
Installation (Fig. 87)
1.
1.  If removed, install ball joints into steering cylinder.
decks, stop  engine, apply parking  brake and remove
key from the ignition switch.
2.
If fittings were removed from steering cylinder, lubri-
cate and place new O--rings onto fittings. Install fittings
intoportopeningsusingmarksmadeduringtheremoval
process  to properly  orientate fittings.  Tighten fittings
(see Hydraulic Fitting Installation in  the General Infor-
mation section of this chapter).
2.
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Read the  General Precautions  for Removing  and
3.
To prevent contamination of hydraulic system during
cylinder removal, thoroughly clean  exterior of cylinder
and fittings.
3.  Slide ram end ball joint through holeon steering arm.
Secure with axle washer and hex slotted nut. Slide fixed
end of cylinder through hole on axle. Secure with slotted
hexnut.Torqueslottedhexnutsto100ft--lbs(135N--m)
and then continue tightening thenutuntilhex nutgroove
aligns with cotter pin hole in ball joint. Install cotter pin
to nut and ball joint.
NOTE:  To ease installation, tag the hydraulic hoses to
show their correct position on the steering cylinder.
4.
5.
and ball  joint spacer  from  the threaded  ends of  ball
joints.Removesteeringcylinderwithballjointsfromma-
chine.
Remove hydraulic hoses from steering cylinder.
Remove cotter pins, slotted  hex nuts, axle washer
4.
Install hydraulic hoses to steering cylinder (see Hy-
draulic Hose and Tube Installation in the General Infor-
mation section of this chapter).
5.
6.
Fill reservoir with new hydraulic fluid as required.
Properly fill hydraulic system (see Charge Hydraulic
6.
cylinder, mark fitting orientation to allow correct assem-
bly. Remove fittings from cylinder and discard O--rings.
If hydraulic fittings are to be removed from steering
System in this section).
7.
If needed, remove ball joints from steering cylinder.
7.
After assembly is completed, operate steering cylin-
dertoverifythathydraulichosesandfittingsarenotcon-
tacted by anything.
Groundsmaster 4000--D/4010--D
Page 4 -- 115
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 340 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website