Component Testing
For accurate resistance and/or continuity checks, elec-
trically disconnect the component being tested from the
circuit (e.g. unplug the ignition switch connector before
doing a continuity check).
CAUTION
When testing electrical components for continu-
ity with a multimeter (ohms setting), make sure
that power to the circuit has been disconnected.
NOTE: For more component testing information, see
the Kubota WorkshopManual, Diesel Engine, 05 Series
at the end of Chapter 3 - Kubota Diesel Engines.
Ignition Switch
Theignition(key)switchhasthreepositions (OFF,RUN,
and START). The terminals are marked as shown. The
circuit wiring of the ignition switch is shown in the chart.
With the use of a multimeter (ohms setting), the switch
functionsmaybetestedtodetermine whethercontinuity
exists between the various terminals for each position.
Verify continuity between switch terminals.
A
B
POSITION
OFF
CIRCUIT
Y
NONE
S
X
RUN
B + I + A, X + Y
B + I + S
START
I
2
1
4
3
Figure 16
1.
2.
Key
Hex nut
3.
4.
Lock washer
Ignition switch
Reelmaster 6500-D/6700-D
Electrical System (Rev. C)
Page 5 - 19
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Reelmaster 6500-D, Toro Reelmaster 6700-D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Product Type | Walk Behind Mower |
| Engine Manufacturer | Toro |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)