Run (ETR) Solenoid (Solenoid With 2 Wire Connector)
The run (ETR) solenoid must be energized for the en-
gine to run. It is mounted on the engine block near the
2
injection pump.
1
In Place Testing
Note:
Prior to taking small resistance readings with a
digital multimeter, short the test leads together. The me-
ter will display a small resistance value (usually 0.5
ohms or less). This resistance is due to the internal re-
sistance of the meter and test leads. Subtract this value
fromfromthemeasured valueofthecomponent youare
testing.
3
Figure 29
1.
2.
Fuel stop solenoid
Pull coil terminal
3.
Hold coil terminal
1.
Disconnect wire harness connector from solenoid.
2.
Using a digital multimeter, touch one test lead to the
pull coil terminal and the other test lead to the fuel stop
solenoid frame (ground) (Fig. 29). The resistance of the
pull coil should be less than 1 ohm (but not zero).
3.
Using a digital multimeter, touch one test lead to the
hold coil terminal and the other test lead to the fuel stop
solenoid frame (ground) (Fig. 29). The resistance of the
hold coil should be approximately 15 ohms.
4.
Connect solenoid to the wiring harness.
Live testing
1.
Disconnect wire harness connector from solenoid.
Note:
The solenoid may be removed from the engine
or tested in place.
2.
sure that the solenoid plunger moves freely and is free
of dirt, debris and corrosion.
If the solenoid is removed from the engine, make
Note:
When testing run solenoid, use test leads with
at least 14 gauge wire.
3.
source to the pull coil and hold coil terminals.
Connect a positive (+) test lead from a 12 VDC
4.
Touch a negative (--) test lead from the 12 VDC
sourcetothefuelstopsolenoidframe(ground)(Fig.29).
The solenoid should engage, making an audible “click,”
and the plunger should retract.
5.
nal. The solenoid should stay engaged.
Remove positive (+) voltage from the pull coil termi-
6.
Remove positive (+) voltage from the hold coil termi-
nal. The solenoid should release.
7.
Reconnect the wires to the solenoid.
Electrical System (Rev. C)
Reelmaster 6500-D/6700-D
Page 5 - 26
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Reelmaster 6500-D, Toro Reelmaster 6700-D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Product Type | Walk Behind Mower |
| Engine Manufacturer | Toro |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)