Removal (Fig. 25)
Park machine on a level surface, lower cutting units,
1.
stop engine, engage parking brake, and remove key
from the ignition switch.
1
2
2.
3.
Release hood latch and open hood.
Disconnect both battery cables at the battery (see
Battery Service in Chapter 5 - Electrical system).
CAUTION
Figure 26
2.
1.
Cable bracket
Cable swivel
The muffler and exhaust pipe may be hot. To
avoid possible burns, allow the exhaust system
to cool before working on or near the muffler.
2
4.
Remove muffler assembly.
5.
Disconnect air filter hoses from the engine and air fil-
1
ter.
3
6.
Remove radiator (see Radiator Removal in this sec-
tion of this manual).
7.
Remove oil cooler and radiator support.
Figure 27
(shown with muffler removed)
DANGER
1.
2.
Oil low pressure switch
Alternator
3.
Starter
Under certain conditions, diesel fuel and fuel va-
pors are highly flammable and explosive. A fire
or explosion from fuel can burn you and others
and can cause property damage.
1
•
•
Use a funnel and fill the fuel tank outdoors,
in an open area, when the engine is off and
is cold. Wipe up any fuel that spills.
Do not fill the fuel tank completely full. Add
fuel to the fuel tank until the level is 1 in. (25
mm) below the bottom of the filler neck. This
empty space in the tank allows the fuel to
expand.
Figure 28
Temperature sender
•
•
Never smoke when handling fuel, and stay
away from an open flame or where fuel
fumes may be ignited by a spark.
Store fuel in a clean, safety-approved
container and keep the cap in place.
1.
11.
Disconnect throttle cable from the swivel on the
speed control lever and the cable bracket (Fig. 26).
12.Disconnect
wires and/or electrical connections from
the following electrical components:
8.
Disconnect all fuel hoses from engine and fuel filter.
To ease reinstallation, mark removed fuel hoses.
A. The oil low pressure switch, starter, and alterna-
tor (Fig 27). The temperature sender (Fig. 28).
9.
Disconnect, mark, and plug all hydraulic lines at the
hydraulic pump assembly.
B. Battery, frame, and wire harness ground to the
engine block and the ETR solenoid (Fig. 29).
10.Disconnect
and plug hydraulic lines and remove hy-
draulic oil filter assembly and bracket.
Reelmaster 6500-D/6700-D
Page 3 - 21
Kubota Diesel Engine
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Reelmaster 6500-D, Toro Reelmaster 6700-D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Product Type | Walk Behind Mower |
| Engine Manufacturer | Toro |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)