Cutting Unit Operating Problems
Problem
Possible Causes
The cutting units remain engaged, but should not, with Seat switch or circuit wiring is faulty.
no operator in the seat.
Electronic Control Module is faulty.
Cutting units run, but should not, when raised. Cutting Up limit switch or circuit wiring is faulty.
units shut off with PTO switch.
Electronic Control Module is faulty.
Cutting units run, but should not, when raised. Cutting Both the up limit switch (or circuit wiring) and PTO
units do not shut off with PTO switch.
switch (or circuit wiring) are faulty.
A hydraulic problem in cutting circuit exists (see
Troubleshooting section of Chapter 4 - Hydraulic
System).
None of the cutting units operate in either direction
(mow or backlap). Cutting units are able to raise and
lower.
PTO switch is in the OFF position.
High coolant temperature disabled cutting units.
NOTE: If the machine is equipped with the optional Turf- Seat switch or circuit wiring is faulty.
Defender
TM
leak detection system, the cutting units will
PTO switch or circuit wiring is faulty.
be shut off if a hydraulic leak is detected. The TurfDe-
alarm should sound to indicate that a hydraulic
fender
TM
Up limit switch or circuit wiring is faulty.
Mow/transport switch or circuit wiring is faulty.
Temperature sender or circuit wiring is faulty.
leak has occurred.
Ground circuit wiring to hydraulic solenoids may be
open.
A hydraulic problem in cutting circuit exists (see
Troubleshooting section of Chapter 4 - Hydraulic
System).
Cutting units run, but should not, when lowered with
joystick and PTO switch in the OFF position.
The PTO switch or circuit wiring is faulty.
Electronic Control Module is faulty.
The front cutting units do not operate in either direction Solenoid MSV2 or circuit wiring is faulty.
(mow or backlap). Rear cutting units operate. Cutting
A hydraulic problem in front mow circuit exists (see
units are able to raise and lower.
Troubleshooting section of Chapter 4 - Hydraulic
System).
The rear cutting units do not operate in either direction Solenoid MSV1 or circuit wiring is faulty.
(mow or backlap). Front cutting units operate. Cutting
A hydraulic problem in rear mow circuit exists (see
units are able to raise and lower.
Troubleshooting section of Chapter 4 - Hydraulic
System).
Reelmaster 5010 Series
Page 5 -- 13
Electrical System
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 5210, Toro 5410, Toro 5510, Toro 5610 |
| Download File |
|
| Document Type | Catalog, Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(1 votes, average: 4 out of 4)
Lawn and Garden readers have rated Toro 06148SL Rev B Reelmaster 5210 5410 5510 5610 Service Manual 4.0 out of 4.0 based on 1 product reviews. i hope is going to work