Flush Hydraulic System
IMPORTANT: Flush the hydraulic system any time
there is a severe component failure or the system is
contaminated. Contaminated oil appears milky or
black or contains metal particles.
8. Make sure traction pedal is in neutral and the PTO
switch is OFF. Turn ignition key switch to start; engage
starter for ten (10) seconds to prime hydraulic pumps.
Repeat this step again.
1.
stop engine, engage parking brake and remove key
from ignition switch.
Park machineonalevelsurface.Lower cuttingunits,
9. Connect fuel stop solenoid to allow engine to start.
10.Start
engineandletitidleatlowspeedforaminimum
of two (2) minutes.
2.
Drain hydraulic reservoir.
11.
Increase engine speed to high idle for minimum of
3.
draulic filters. Remove and discard hydraulic filters.
Clean area around the mounting areas of the hy-
one (1) minute under no load.
12.Rotate
steering wheel in both directions several
4.
and components while the system is warm. Flush hoses
and tubes to remove any contamination.
Drain entire hydraulic system. Drain all hoses, tubes
times. Raise and lower cutting units several times.
13.Shut
off engine and check for hydraulic oil leaks.
Check oil level in hydraulic reservoir and add correct oil
if necessary.
IMPORTANT: If a failure occurred in the traction cir-
cuit, traction circuit component disassembly and
thorough cleaning may be required to remove con-
taminates from the traction circuit. Because the
traction circuit is a closed loop, any contamination
will remain in the circuit and can cause additional
component damage unless it is removed.
14.Operate
the machine for two (2) hours under normal
operating conditions.
15.Check
conditionofhydraulicoil.Ifthefluidshowsany
signsofcontamination,repeatsteps1through14again.
16.Resume
maintenance intervals.
normal operation and follow recommended
5.
Make sure the mounting surfaces of the hydraulic fil-
tersareclean.Applycleanhydraulicoiltogasketonnew
filters. Screw filters on until gasket contacts mounting
plate, then tighten filter 3/4 turn.
IMPORTANT: Use only hydraulic fluids specified in
Traction Unit Operator’s Manual. Other fluids could
cause system damage.
6.
Fill hydraulic reservoir with new hydraulic oil.
7.
noid to prevent the engine from starting.
Disconnect electrical connector to the fuel stop sole-
Hydraulic System
Page 4 -- 56 Rev. B
Reelmaster 5010 Series
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 5210, Toro 5410, Toro 5510, Toro 5610 |
| Download File |
|
| Document Type | Catalog, Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(1 votes, average: 4 out of 4)
Lawn and Garden readers have rated Toro 06148SL Rev B Reelmaster 5210 5410 5510 5610 Service Manual 4.0 out of 4.0 based on 1 product reviews. i hope is going to work