Removal (Fig. 51)
Installation (Fig. 51)
1.
Tilt hydraulic reservoir cover up to access reservoir.
1. If fittings were removed from reservoir, lubricate and
place new o--rings onto fittings. Install fittings into reser-
voir openings using marks made during the removal
process to properly orientate fittings. Tighten fittings
(see Hydraulic Fitting Installation in the General Infor-
mation section of this chapter).
2.
hydraulicreservoirtopreventhydraulicsystemcontami-
nation.
Thoroughlycleanhydraulichoseendsandfittingson
3.
Drain hydraulic oil from reservoir.
2.
Lubricatenewsuctionstrainero--ringandinstallonto
4.
Label hydraulic hoses to assist in installation. Dis-
strainer. Thread suction strainer into hydraulic reservoir
until finger tight. Then, using a wrench, turn strainer into
reservoir port 1--1/2 to 2 full turns beyond finger tight.
connect all hydraulic hoses and tubes from fittings on
thereservoir.Allowhydrauliclinestodrainintoasuitable
container. Plug or cap openings of reservoir and lines to
prevent contamination.
3.
Position hydraulic reservoir to machine. Secure re-
servoir to frame with two (2) clamps (item 13), washer
head screws (item 26) and flange nuts (item 27).
5.
guide.
Remove hydraulic reservoir using Figure 51 as a
4.
tings during the removal process.
Remove all plugs and caps placed in hoses and fit-
6.
ring.
Remove suction strainer from reservoir. Discard o--
5.
voir in positions noted during removal.
Install hydraulic hoses to fittings on hydraulic reser-
7.
mark fitting orientation to allow correct assembly. Re-
move fittings from reservoir and discard o--rings.
If hydraulic fittings are to be removed from reservoir,
6.
7.
8.
forleaks.Tightenanylooseconnections.Checkhydrau-
lic oil level and adjust if necessary.
Fill hydraulic reservoir with new hydraulic fluid.
Lower and secure reservoir cover.
Inspection (Fig. 51)
1.
solvent.
Clean hydraulic reservoir and suction strainer with
Operate machine. Check hydraulic lines and fittings
2.
Inspect hydraulic reservoir for leaks, cracks or other
damage.
Reelmaster 5010 Series
Page 4 -- 59
Hydraulic System
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 5210, Toro 5410, Toro 5510, Toro 5610 |
| Download File |
|
| Document Type | Catalog, Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(1 votes, average: 4 out of 4)
Lawn and Garden readers have rated Toro 06148SL Rev B Reelmaster 5210 5410 5510 5610 Service Manual 4.0 out of 4.0 based on 1 product reviews. i hope is going to work