Removal (Fig. 8)
Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
Installation (Fig. 8)
1.
1. Thoroughly clean the rear axle pivot pin. Inspect the
pin for wear or damage and replace if necessary.
2.
Position the rear axle assembly to the frame. Install
2.
3.
steering cylinder to prevent hydraulic system contami-
nation.
Chock frontwheelstopreventmachine fromshifting.
Thoroughlycleanhydraulichoseendsandfittingson
thrust washer (item 7) between each side of axle and
frame. Raise axle assembly to frame and slide pivot pin
through frame, thrust washers and axle. Make sure that
roll pin on pivot pin is positioned in frame reliefs.
3.
Install thrust washer (item 9) and jam nut (item 10)
NOTE: To ease assembly, label hydraulic hoses to
show their correct position on the steering cylinder.
onto pivot pin. Torque jam nut (item 10) from 90 to 120
ft--lb(123to162N--m).Make sure thataxlecan stillpiv-
ot freely after jam nut is tightened.
4.
Disconnect the hydraulic hoses from the steering
cylinder. Put caps or plugs on all fittings and hoses to
prevent contamination.
4.
5.
Lower the machine to the ground.
Correctly install the hydraulic hoses to the steering
5.
Remove the jam nut (item 10) and thrust washer
(item 9) that secure the axle pivot pin (item 6) to the
frame.
cylinder.
6. Check oil level in hydraulic reservoir.
6.
Jack up the machine (just ahead of the rear wheels)
7. Lubricate the rear axle pivot bushings through the
grease fitting on the axle pivot pin.
until clearance exists to allow rear axle removal. Sup-
port the machine with jack stands or appropriate load
holding device to prevent it from falling.
8.
Operate machine and check steering cylinder hy-
draulic connections for leaks.
7.
8.
will release the rear axle and thrust washers (item 7)
from the frame. Carefully pull the entire axle and wheel
assembly out from under the machine.
Support rear axle to prevent it from falling.
Pull the axle pivot pin from frame and rear axle. This
Reelmaster 5010 Series
Page 6 -- 13
Chassis
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 5210, Toro 5410, Toro 5510, Toro 5610 |
| Download File |
|
| Document Type | Catalog, Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(1 votes, average: 4 out of 4)
Lawn and Garden readers have rated Toro 06148SL Rev B Reelmaster 5210 5410 5510 5610 Service Manual 4.0 out of 4.0 based on 1 product reviews. i hope is going to work