TEST NO. 2: Implement Relief Pressure (Fig. 9)
Using a low pressure gauge: 0 - 1000 psi
hydraulic circuit. This is can be caused by parts that are
binding or build up of debris under the cutting unit. This
adds to the amount of force that the hydraulic cylinder
must overcome. Repair such items before continuing
with the hydraulic tests.
1.
2.
Perform steps 1 - 7 under Charge Pressure Test.
While observing the gauge, move the lift control lever
to the RAISE position. While holding the lever in the
RAISE position, look at the pressure reading on the
gauge. The gauge should show 700 - 800 psi. Stop the
engine and move the lift control lever to the LOWER
position to lower the implement to the ground.
If adding shims to the relief valve does not increase the
pressure, inspect the condition of the charge pump
gerotor and internal housing.
If the charge pump is in good condition (no scoring,
scratches, or excessive wear), the general condition of
the transmission’s piston pump and piston motor might
be suspected of wear and inefficiency.
3.
relief valve by adding the required amount of shims from
the shim pack.
If the pressure is below 700 psi, adjust the implement
A lack of sufficient implement pressure could be due to
the fact that the charge pump is having to direct most of
its flow to the main traction circuit (piston pump and
piston motor). When this occurs, oil pressure may not
increaseto the700 - 800psipressurenecessary toraise
the heavy implement.
CAUTION
The implement relief pressure must not ex•
ceed 800 psi.
At this point, a traction pressure test could be used to
determine whether the hydrostatic transmission has
excessive piston group leakage and needs to be
repaired. (See Traction Pressure Test.)
NOTE: When testing the implement relief valve pres•
sure, it may be found that the pressure is already set to
the 800 psi maximum. If this is so, a slow or no lift
condition is most likely caused by an added force being
applied to the lift system and not a fault within the
Testing
Page 5 - 20
Groundsmaster® 300 Series
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews. Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems