Seat Switch (Fig. 6, 7)
The seat switch is a normally open (N.O.) switch that
closes when the operator is on the seat. If the PTO
switch or traction switch is open and the operator raises
off the seat, the engine will stop.
1. Raise the seat to get access to the seat switch wiring
connector.
2.
Disconnect the seat switch wiring connector and
install a continuity tester or ohm meter between the two
leads of the seat switch.
3. Lower the seat. The continuity tester should show no
continuity.
NOTE: Make sure the compression spring and pin holds
the seat up off the seat switch when there is no operator
on the seat.
Figure 6
(S/N Below 30001)
4. Have the operator sit on the seat, slowly depressing
the seat switch. The continuity tester should show con•
tinuity as the seat approaches the bottom of its travel.
(See Replacing Seat Switch in Repairs section of this
chapter for replacement and adjustment procedures.)
1. Connectors
3. Switch
2. Capscrew & locknut
4. Mounting bracket
Figure 7
(S/N 30001 and UP)
1. Seat switch
4. Spring
2. Seat support bracket
3. Connector
5. Pin
Groundsmaster® 300 Series
Page 6 - 19
Testing
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews. Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems