Traction Control Neutral Adjustment (Fig. 13)
1.
Park vehicle on a level surface and turn engine off.
D. Weak or damaged leaf springs.
Apply the parking brake, tip seat forward, and actuate
pump lever (Fig. 13) to ensure assembly is properly
seated and operating freely. Correct any discrepancy.
E. Pump lever loose on transmission control shaft.
Makesurethatfastenersaretight(boltsorspringpin).
If necessary, remove pump lever from control shaft,
apply Loctite #680 (or equivalent) to shaft and reat-
tach pump lever.
2.
Jack up frame so left front wheel is off the ground. On
four wheel drive machines, jack up frame so at least one
rearwheelisalsoofftheground.Usejackstands tosup-
port the raised machine.
F. Internal transmission component malfunction (see
Repairs section of this chapter).
3.
Blockwheelsthatareonthegroundsovehiclecannot
roll forward or backward.
8.
9.
Shut engine off.
4.
Start engine and allow it to idle for 5 minutes to heat
oil in transmission to operating temperatures.
Adjust traction control rod; refer to Traction Control
Rod Adjustment in this section.
5.
Release parking brake; then check that wheel(s) that
10.
essary.
Check operation of neutral switch and adjust if nec-
are off the ground are NOT rotating. Check for wheel
rotation with throttle in both SLOW and FAST position.
If wheel(s) that are off the ground are NOT rotating, pro-
ceed to step 8 as no adjustment is necessary.
6.
the pump plate must be adjusted as follows:
If the wheel(s) that are off the ground ARE rotating,
SWITCH
ADJUSTING
SCREW
A. Move throttle to SLOW.
CAPSCREW
B. Loosen three (3) capscrews that secure pump
plate to transmission.
C. If wheel is rotating forward, lightly tap bottom of
pump plate counterclockwise. By contrast, tap pump
plate clockwise if wheel is rotating backward. When
wheel stops rotating, tighten capscrews to secure
pump plate.
BALL
BEARING
LEAF
SPRINGS
PUMP
PLATE
PUMP
D. Check that wheel(s) that are off the ground are
NOT rotating with throttle in both SLOW and FAST
position. If necessary, repeat pump plate adjustment
until wheels do not rotate.
LEVER
Figure 13
7.
tate after adjustment procedure, check for the following:
Shouldwheel(s)thatareoffthegroundcontinuetoro-
A. Ball bearing is loose or worn.
B. Plunger on interlock switch is sticking.
C. Fasteners on pump control assembly are loose or
missing.
Adjustments
Page 5 -- 24
Rev. I
Groundsmaster 300 Series
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews. Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems