Camshaft and Bearing (Fig. 65, 66)
1. Inspect the camshaft for evidence of severe wear.
2. Using a micrometer and a hole gauge, measure the
clearance between the camshaft journals and the cylin•
der block. If the clearance is greater than 0.0059 inch
(0.15 mm) the camshaft or the camshaft bushing must
be replaced.
3. To remove the camshaft bushing in the cylinder block,
carefully drive the bushing from its location using the
camshaft bushing tool (refer to “Special Tools”).
NOTE: You must drive the bushing into the cylinder
block and then crush it to remove it. Be careful not to
damage the valve lifter hole when removing the cam•
shaft bushing.
Figure 65
Removing camshaft bushing
4. To install a new camshaft bushing use the camshaft
bushing tool and drive the bushing in from the outside
of the cylinder block being careful to align the oil delivery
hole in the cylinder block with the oil hole in the bushing.
5. If the cam surface is damaged or the cam lobe is badly
worn it must be replaced. Cam lobe height should be
measured using a micrometer. The standard cam lobe
height for both intake and exhaust valves is 1.4079
inches (35.75 mm). The maximum allowable wear on
cam surface is 0.0394 inch (1.0 mm). Replace the
camshaft if wear exceeds this amount.
Figure 66
Measuring camshaft cam lobe height
Fuel Injection Pump Camshaft (Fig. 67)
1. Inspect the camshaft bearing, replace if defective.
2. Examine the oil pump coupling. The camshaft must
be replaced if this coupling is worn.
3. Examine the cam lobe surfaces. Replace the cam if
they are damaged.
4. Measure the cam lobe height in the same manner as
measuring the valve camshaft lobe height. The standard
lobe height for each cylinder of the injection pump is
1.7323 inches (44 mm). The camshaft must be replaced
if the cam lobe has been worn by 0.0394 inch (1 mm)
or more.
Figure 67
Fuel injection pump camshaft
Groundsmaster® 300 Series
Page 4 - 55
Cylinder Block Overhaul
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5) Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews.
Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems