Repairs
Axle Removal and Installation
1.
Put machine on a level surface, lower cutting unit,
stop the engine and remove key from ignition switch.
Block rear wheels to prevent machine from moving.
2. Remove the cutting unit. (See the Repairs section of
Chapter 11 - Cutting Units.)
3. If unit is equipped with 4WD, remove rear axle drive
shaft (see Chapter 9 - 4WD Rear Axle).
4. Remove hydrostatic transmission. (See Repairs sec•
tion of Chapter 5 - Hydraulic System.)
5. Slightly loosen all front wheel lug nuts. Jack both front
wheels off the ground and install jackstands or blocks
under traction unit frame (not axle tubes) to prevent
machine from falling. Remove both front wheels.
Figure 3A
Figure 3B
Figure 3C
6. Remove extension spring and clevis pin to disconnect
brake cable from brake actuating lever on each brake.
7. Remove capscrew securing axle support bracket to
top of differential. Loosen nuts securing axle support
bracket to frame (Fig. 3A).
8. Put a jack or blocking under differential to hold it in
place. Remove capscrews and locknuts securing axle
mounting pads to frame. Note number of shims between
frame and axle mounting pad, which are used to get
correct engine to transmission alignment (Fig. 3B).
Carefully lower axle and pull it out from under trac•
tion unit.
9. If unit is equipped with 4WD, remove nut (Fig. 3C,
Item 20), washer (Item 21) and flange (Item 22) from
differential axle pinion (Item 8). Use Differential Gear
Holder tool to gears when removing nut.
NOTE: Before installing flange (for 4WD drive shaft),
apply Permatex No. 2 to external splines of pinion and
internal splines of flange. Tighten lock nut to secure
pinion coupler 75 - 90 ft-lb (102 - 122 N-m).
10.
To install axle, reverse steps 1 - 9. Leave axle
mounting pad nuts loose. Install shims (P/N 42-6080)
between axle mounting pads and frame to get correct
engine to transmission alignment, then tighten axle
mounting nuts.
Groundsmaster® 300 Series
Page 7 - 3 (Rev. F)
Repairs
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews. Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems