Mounting Cutting Unit to Traction Unit (Fig. 14, 15, 16, 17)
1.
engine off.
Position machine on level surface and shut
8. Line up holes in yoke and input shaft of gear box.
Slide yoke onto shaft and secure parts together with roll
pin. Tighten (2) capscrews and locknuts securing yoke
to input shaft.
2. Move cutting unit into position in front of traction unit.
9. Mount PTO shield over input shaft and onto gear box
mounting plate with two self-tapping screws.
WARNING
10. Connect lift chains to lift arm and cutting unit chain
brackets with (6) shackles, shackle pins and cotter pins.
To make sure cutting unit lifts properly, secure chains to
the following links when connecting:
Since the right hand push arm is spring
loaded to about 100 pounds and left hand
push arm is spring-loaded to about 150
pounds, a helper is needed to push the push
arm down. Sudden release of the push arm
could cause injury.
Front left – 11th link�
Front right – 8th link�
Rear – 7th link�
3. Have a helper carefully push down on right hand push
arm until holes in ball joint mount line up with holes in
caster arm.
11. Check operation to make sure chains lift deck tight
against stops when lift arm is raised.
4. Secure ball joint mount to caster arm with capscrews,
flat washers and flange nuts. Flat washers must be
installed to outside of caster arm.
5. Have a helper carefully push down on left hand push
arm until holes in ball joint mount are in line with holes
in mount bracket on cutting unit. Immediately slide 4 x 4
in. block of wood between top of push arm and under-
side of chassis.
WARNING
Make sure wooden block does not slip out
accidentally.
Figure 17
1. Front left lift chain
2. Front right lift chain
3. Rear lift chain
6. Secure ball joint mount and chain bracket to caster
arm with capscrews, flat washers and flange nuts. Flat
washers must be installed to outside of caster arm.
Chain bracket must be installed using forward set of
holes.
7. Carefully remove wood block holding push arm down.
Groundsmaster® 300 Series
Page 13 - 13
Repairs
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews. Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems