Transmission By-Pass Valve (Fig. 16)
1.
Place a drain pan below the by-pass valve.
2.
Remove the by-pass valve assembly from the center
section by turning it counterclockwise. Some oil may
flow into the drain pan.
3.
Inspect the threads onthe by-pass valve. Replace the
valve if the threads are damaged.
4.
Check the O-ring and back-up ring for damage.
If the parts are damaged, replace them.
5.
If the O-ring or back up ring was removed
because of damage, slide the new back up ring into the
groove at the center of the valve, then install the O-ring
into the same groove.
Figure 16
1.
Transmission by-pass valve
6.
To install the by-pass valve, screw it into the center
section. Tighten the valve to 5 - 8 ft-lb.
7.
Since some oil drained out of the transmission when
the by-pass valve was removed, check the oil level in
the axle housing. Start the engine and let it run for about
one or two minutes. Then turn the engine off and check
the oil level in the axle housing again. Also, inspect the
by-pass valve area for oil leaks.
Groundsmaster® 300 Series
Page 5 - 27 (Rev. H)
Repairs
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews. Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems