Chapter 1
Safety
SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . 1
Before Operating . . . . . . . . . . . . . . . . . . . . . . . . . 1
While Operating. . . . . . . . . . . . . . . . . . . . . . . . . . 2
While Doing Maintenance, Troubleshooting,
Testing, Adjustments or Repairs . . . . . . . . . . . . . 3
Safety Instructions
The Groundsmaster 300 Series was tested and certified
by TORO for compliance with the B71.4 1984 specifica•
tions of the American National Standards Institute. Al•
though hazard control and accident prevention partially
are dependent upon the design and configuration of the
machine, these factors are also dependent upon the
awareness, concern, and proper training of the person•
nel involved in the operation, transport, maintenance,
and storage of the machine.
CAUTION
Improper operation, maintenance, trou•
bleshooting, testing, adjustments or repairs
of the machine can result in injury or death.
To reduce the potential for injury or death,
comply with the following safety instructions.
Before Operating
1. Read and understand the Operator’s Manual before
starting and operating the machine. Become familiar
with all controls and know how to stop quickly. A replace•
ment manual is available by sending complete Model
and Serial Numbers to:
6. Do not wear loose fitting clothing because it could get
caught in moving parts. Always wear long pants and
substantial shoes. Wearing safety glasses, safety
shoes, and a helmet is advisable and required by some
local ordinances and insurance regulations.
The Toro Company
8111 Lyndale Avenue South
Minneapolis, Minnesota 55420
7. Be sure interlock switches are adjusted correctly so
engine cannot be started unless traction pedal is re•
leased to neutral position and PTO lever is in OFF
position.
2. Never allow children to operate the machine. Do not
allow adults to operate the machine without proper
instruction. Only trained operators, skilled in slope op•
eration and who have read the Operator’s Manual
should operate this machine.
8. Grass deflectors must be installed in lowest position
on side discharge cutting units and properly attached to
®
Triflex cutting unit wings.
9. Fill fuel tank with the proper fuel before starting the
engine. Avoid spilling any fuel. Since fuel is very flam•
mable, handle it carefully.
3. Never operate machine when under the influence of
drugs or alcohol.
4.
Remove all debris or other objects that might be
A. Use an approved fuel container.
picked up and thrown by cutter blades or fast moving
components from other attached implements. Keep all
bystanders away from the operating area.
B. Do not fill fuel tank when engine is hot or running.
C. Do not smoke while handling fuel.
5.
Keep all shields and safety devices in place. If a
shield, safety device, or decal is defective or damaged,
repair or replace it before operating the machine. Also,
tighten any loose nuts, bolts, and screws to make sure
machine is in safe operating condition.
D. Fill fuel tank outdoors and up to about one inch
(25 mm) from the top of the tank, not the filler neck.
E. Wipe up any spilled fuel.
Groundsmaster® 300 Series
Page 1 - 1
Safety Instructions
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5) Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews.
Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems