Inspecting and Sharpening Blade
1. Raise cutting unit to highest position, shut the engine
off and engage parking brake. Block cutting unit to
prevent it from falling accidentally.
2.
Examine cutting ends of the blade carefully, espe•
cially where the flat and curved parts of the blade meet.
Since sand and abrasive material can wear away the
metal that connects the flat and curved parts of the
blade, check the blade before using the machine. If any
wear is noticed, replace the blade: refer to Removing
Cutter Blade.
Figure 8
WARNING
If the blade is allowed to wear, a slot will form
between the sail and flat part of the blade.
Eventually, a piece of the blade may break off
and be thrown from under the housing, pos
sibly resulting in serious injury to yourself or
bystander.
3.
Examine cutting edges of all blades. Sharpen the
cutting edges if they are dull or nicked. Sharpen only the
top side of the cutting edge and maintain the original
cutting angle to assure sharpness. The blade will remain
balanced if same amount of metal is removed from both
cutting edges.
Figure 9
4.
To check blade for being straight and parallel, lay
blade on level surface and check its ends. Ends of blade
must be slightly lower than the center, and cutting edge
must be lower than heel of the blade. This blade will
produce good quality of cut and require minimal power
from the engine. By contrast, a blade that is higher at
the ends than the center, or cutting edge higher than the
heel of the blade is warped or bent and must be re•
placed.
5. To install the blade, ,assemble parts in reverse order,
and make sure the blade sail is facing up. Tighten
special screw to 75 to 100 ft-lb.
Groundsmaster® 300 Series
Page 11 - 9
Repairs
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews. Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems