34.
Put the three 1/2 in. (13 mm) springs into the spring
pockets of the isolation manifold (Fig. 97).
NOTE: Two different length springs are used in the unit.
Be sure to use the 1/2 in. (13 mm) length springs during
this part of the assembly.
Figure 97
Figure 98
Figure 99
35.
Apply clean grease to a seal ring and put it in the
valve ring recess that will face down when installed.
Install the valve ring over the bolts and alignment pins
with the seal ring facing the isolation manifold (Fig. 98).
IMPORTANT: Be sure the seal ring is seated cor
rectly after the valve ring is assembled.
36.
Put the hex drive assembly, pin side up, through the
hole in the isolation manifold (Fig. 99). the slot in the hex
drive must be engaged with the SMALL tang of the drive
link. Turn the input shaft to assist the engagement.
NOTE: If the hex drive does not readily assemble on the
drive link, the drive link was assembled incorrectly (See
step 22 of this procedure.)
Groundsmaster® 300 Series
Page 8 - 47
Repairs
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems