0.34
± 0.03″
Arrow end of roller
clutches must face
3
1
30
29
37
36
6-bolt flange end of
A
0.040″ MAX
clutch housing
toward rear axle)
30
B
Apply
Never-seeze
34
Detail A
Detail B
B
31
35
33
32
39
Figure 9
5.
Put thrust washer (Item 14) in housing adjacent to
Installing Drive Shaft.
roller clutch as shown. Press both seals (Item 13) into
end of housing to dimensions shown. Seals must be
installed with lip facing out.
1. Apply never-seize to splines of traction shaft and axle
input shaft.
6. Install clutch assembly onto yoke shaft, then install
other thrust washer. Install retaining ring (Item 29) to
secure clutch assembly to shaft. Install axle coupling
(Item 37) to clutch housing with six (6) capscrews and
lockwashers, then tighten capscrews evenly.
2. Slide clutch end of drive shaft onto rear axle shaft
spline, aligning roll pin hole in shaft with hole in axle
coupling (Item 37). Install roll pin (Item 35) through
coupling and shaft.
3.
Tighten two (2) capscrews (Item 44) and locknuts
7. Lubricate clutch through grease fitting (Item 32) with
No. 2 General Purpose Lithium Grease.
(Item 43) to secure coupling to shaft.
4. Secure drive shaft yoke flange to flange on front axle
differential with six (6) socket head capscrews and
lockwashers (not shown).
Repairs
Page 10 - 6
Groundsmaster® 300 Series
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems