Caster Arm Bushing Service (Fig. 11)
The caster arms have bushings pressed into the top and
bottom portion of the tube and after many hours of
operation, the bushings will wear. To check the bush•
ings, move caster fork back and forth and from side-to-
side. If caster spindle is loose inside the bushings,
bushings are worn and must be replaced.
1. Raise cutting unit and block it so it cannot fall acci•
dentally.
2.
Remove lynch pin and spacers from top of caster
spindle.
3.
Pull caster spindle out of mounting tube. Allow
spacer(s) and thrust washer to remain on bottom of
spindle to assure same height of cut when caster spin•
dle is reinstalled.
Figure 11
4. Insert pin punch into top or bottom of mounting tube
and drive bushing out of tube. Also drive other bushing
out of tube. Clean inside of tubes to remove dirt.
5. Apply grease to inside and outside of new bushings.
Using a hammer and flat plate, drive bushings into
mounting tube.
6.
Inspect caster spindle for wear and replace it if
damaged.
7. Push caster spindle through bushings and mounting
tube. Slide spacers onto spindle. Install lynch pin
through caster spindle to retain all parts in place.
Groundsmaster® 300 Series
Page 11 - 11
Repairs
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems