Adjustments
Rear Wheel Toe-in (Fig. 6)
1. Measure center–to–center distance (at axle height)
at front and rear of steering tires. Front measurement
must be 0 to 1/8 in. less than rear measurement.
2. Remove cotter pin and nut securing one tie rod ball
joint to mounting bracket on axle and disconnect ball
joint from axle (Fig. 7).
3. Loosen screw on tie rod clamp. Rotate ball joint in or
out to adjust length of tie rod.
4.
Reinstall ball joint ot mounting bracket and check
wheel toe-in.
5. After getting correct adjustment, tighten screw on tie
rod clamp and connect ball joint to mounting bracket
with nut and cotter pin.
Figure 6
1. Ball joint
2. Tie rod
3. Tie rod clamp
Steering Stop Adjustment (Fig. 7)
The rear axle steering stops help prevent over travel of
the steering cylinder in case of impact on rear wheels.
The stops should be adjusted so there is 0.090 in.
clearance between bolt head and knuckle on axle when
steering wheel is completely turned left or right.
1.
Thread bolt in out out unitl 0.090 in. clearance is
attained (Fig. 7)
Figure 7
1. Steering stops
Adjustments
Page 10 - 4
Groundsmaster® 300 Series
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems