PTO Drive Shaft Removal (Fig. 15)
DANGER
Do not start the engine and engage the P.T.O.
lever when the P.T.O. shaft is not connected
to the gearbox on the cutting unit. If the en
gine is started and the P.T.O. shaft Is allowed
to rotate, serious Injury could result.
1.
Position the machine on a level surface, lower the
cutting unit to the shop floor, turn the engine off, remove
the key from the ignition switch, and engage the parking
brake.
Figure 15
2. Remove the self-tapping screws securing the shield
behind the cutting unit gear box and set the shield aside.
1. PTO yoke
2. Yokes in phase
3. Roll pin
4. Capscrews & locknuts
3. Drive the roll pin out of the yoke and the input shaft
of the gearbox. Slide the yoke off of the input shaft. If
the traction unit will be used without the cutting unit,
drive the roll pin out of the yoke at the P.T.O. pivot shaft
and remove the entire universal shaft from the traction
unit.
Repairs
Page 9 - 12
Groundsmaster® 300 Series
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems