Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual

10. Sit on the seat when starting the engine and oper•
ating the machine.
If movement is evident, the neutral return mecha•
nism  is  adjusted  incorrectly.  Shut  engine  off  and
adjust until machine does not move when traction
pedal is released.
11.
On  machines  equipped  with  roll-over  protection
(ROPS),  always  use  seat  belt  and  ROPS  together.
Make sure seat pivot retaining pin is installed.
13. Do not run the engine in a confined area without
adequate ventilation. Exhaust fumes are hazardous and
could possibly be deadly.
12. Before starting the engine:
A. Engage parking brake,
14. Maximum seating capacity is one person. Therefore,
never carry passengers.
B. Make sure traction pedal is in neutral and PTO is
in OFF (disengage) position.
15.  Check  carefully  for  overhead  clearances  before
driving under any objects.
C. After engine is started, release parking brake and
keep foot off traction pedal. Machine must not move.
While Operating
16.
plete attention. To prevent loss of control:
Using the machine demands the operator’s com•
21. The grass deflector(s) must always be installed and
in lowest position on the cutting unit. This product is
designed to drive objects into the ground where they
lose energy quickly in grassy areas. However, don’t take
an injury risk!! When a person or pet appears unexpect•
edly  in  or  near  the  mowing  area,  STOP  MOWING.
Careless operation, combined with terrain angles, rico•
chets,  or  improperly  positioned  guards,  can  lead  to
thrown object injuries. Do not resume mowing until area
is cleared.
A. Operate only in daylight or when there is good
artificial light.
B. Drive slowly.
C. Avoid sudden stops and starts.
D. Look behind machine before backing up.
E. Watch for holes or other hidden hazards.
22. Never raise the cutting unit or other attached imple•
ment while the blades or other parts are rotating.
F. Do not drive close to a sand trap, ditch, creek, or
hazard.
23. If cutting blades or other implement components
strike a solid object or the machine vibrates abnormally,
disengage PTO, move throttle to SLOW, set parking
brake, and shut engine off. Remove key from switch to
prevent possibility of accidental starting. Check cutting
unit or other implement and traction unit for damage and
defective parts. Repair any damage before restarting
the engine and operating the implement or cutting unit.
Assure cutting unit blades are in good condition and
blade bolts are torqued to proper specifications (See
Cutting Unit Operator’s Manual).
G.  Reduce  speed  when  making  sharp  turns  and
when turning on a hillside
H. The cutting deck must be lowered when going
down slopes for steering control.
17. To maintain machine control, 35 lb. of weight must
be mounted on rear of traction unit before using the
Triflex 88" cutting unit. More weight may be required in
some steeper slope conditions.
24. To stop machine, remove foot from traction pedal
and use brakes. Gradually reversing the traction pedal
can provide additional braking.
18. Operator must be skilled and trained in how to drive
on hillsides. Failure to use caution on slopes or hills may
cause loss of control and vehicle to tip or roll possibly
resulting in personal injury or death.
25. Do not touch engine, muffler, or radiator while engine
is running or soon after it has stopped. These areas
could be hot enough to cause a burn.
19. Traverse slopes carefully. Do not start or stop sud•
denly when traversing slopes or when traveling uphill or
downhill.
26. Lower the cutting unit or other attached implement
to the ground and remove key from switch whenever
machine is left unattended.
20.
If  engine  stalls  or  machine  loses  headway  and
cannot make it to the top of a slope, do not turn machine
around. Always back slowly straight down the slope.
Safety Instructions
Page 1 - 2
Groundsmaster® 300 Series
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 402 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(2 votes, average: 5 out of 5)
Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual SKU UPC Model
Michael on Nov 30, 2017. 34974

Need 328D. Manual pdf. Will rate after finding manual


barry on Feb 07, 2013. toro groundsmaster 322d

t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems


Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website