Temperature Relay (Fig. 18)
The temperature relay (Fig. 18, Item 18) works with the
temperature gauge to disconnect battery voltage to the
ignition system (gas engine) or fuel shut stop control unit
(diesel engine) if the engine temperature gets too hot.
The B & C terminals of the temperature relay have a
normally closed connection between them. If there is no
continuity between terminals B & C check the SFE-14
fuse inside the relay box.
A coil resistance may be read on the ohmmeter between
terminals B & S. No resistance, indicates an open coil.
If the coil is open, replace the temperature relay device.
Figure 18
Temperature Gauge Sending Unit (Fig. 19)
The temperature gauge sending unit is located on the
top of the cylinder head, near the thermostat .
1. Lower the coolant level in the engine and remove the
temperature gauge sending unit located near engine
thermostat.
2.
Put the sending unit in a container of oil with a
thermometer and heat the oil.
3. With an Ohm meter connected as shown, the resis•
tance readings should changed as the temperature
increases (resistance should get lower as temperature
gets higher).
Figure 19
CAUTION
Handle hot oil with special care to prevent
personal injury or fire.
Groundsmaster® 300 Series
Page 6 - 27
Testing
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems