Installing Push Arms,
Torsion Springs and Bushings
1. Apply grease to inside and outside of new bushings.
Using a hammer and flat plate, carefully drive the bush•
ings into the push arm pivot tubes. The bushings must
be flush with the end of the tube.
2. Inspect the torsion springs. If the springs are dam•
aged, use new springs when assembling the parts.
3. Slide the torsion springs onto the inside of the push
arm pivot tubes. Install the washers, push arms with
springs and push arm brackets onto the pivot shaft.
Install the roll pins to secure the parts in place.
Figure 28
4.
Raise the push arm and pivot shaft assembly into
position and secure it in place with cap screws, support
plate, reinforcement support and locknuts. Make sure
the springs contact the retainer plate on the push arms
and the underside of the frame.
5. Have a helper push down on the left push arm while
you place a 3 ft. long block of wood between the chassis
and to top of the push arms, across the full width of the
machine.
NOTE: After the wood block is installed, there should be
enough clearance for installing the ball joint into the front
of the push arm.
6.
Thread jam nut fully onto the left-hand ball joint.
Screw the ball joint into the left-hand push arm until the
center of the ball joint is 2-3/8 inches away from the front
of the push arm. Do not tighten the jam nut until the deck
is mounted.
7. Install the brake mount and pedal assembly with cap
screws, locknuts, carriage bolts, lock washer and nuts.
Route the right-hand brake cable through the hole in the
right-hand push arm bracket. Connect the cable to the
brake strut with the clevis pin and the tension spring.
Hook the opposite end of the tension spring into the hole
in the side of the chassis. Also install the cable into the
mount on the frame.
Repairs
Page 11 - 20
Groundsmaster® 300 Series
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(2 votes, average: 5 out of 5)
Lawn and Garden readers have rated Toro 92801SL Rev I Groundsmaster 300 Series Groundsmaster 328 D Service Manual 5.0 out of 5.0 based on 2 product reviews. Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems