Separating Cutting Unit From Traction Unit (Fig. 14, 15, 16, 17)
1. Position machine on level surface, lower cutting unit
to the shop floor, shut engine off and engage parking
brake.
2. Remove self-tapping screws securing shield to top of
cutting unit and set shield aside.
3. Drive roll pin out of yoke and input shaft of gear box.
Also, loosen cap screws and lock nuts. Slide yoke off
the input shaft. If traction unit will be used without the
cutting unit, drive roll pin out of yoke at PTO pivot shaft
and remove entire universal shaft from traction unit.
Figure 14
DANGER
Do not start the engine and engage the PTO
lever when PTO shaft is not connected to gear
box on cutting unit. If engine is started and
PTO shaft is allowed to rotate, serious injury
could result.
1. PTO yoke
2. Yokes in phase
3. Roll pin
4. Capscrews & locknuts
4.
Disconnect spring from lift cylinder cotter pin. Re•
move cotter pins and clevis pins securing lift chains to
lift arm.
Figure 15
1. PTO shield
4. Spring in 4th link
2. Self-tapping screws
3. Lift chain
5. Spring in cotter pin
Repairs
Page 11 - 14
Groundsmaster® 300 Series
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 300, Toro Groundsmaster 328 D, Toro Groundsmaster 92801SL |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
Need 328D. Manual pdf. Will rate after finding manual
t has been a very reliable machine but getting parts is hard and not cheap to buy , generic parts has been cost effective and reliable , i am unable to get a wiring circut diagram for this unit as most problems are electrical problems